The reason why the motor is burned out is many, but the correct use of the pump is one of the important reasons.
When using the water pump, after turning on the power supply, carefully observe the operation of the water pump. The water should be continuously and evenly distributed. The pump can be used without vibration and noise. If it suddenly stops during operation, immediately disconnect the power supply and check the cause. The interval between the two start times of the pump shall be limited to the total return of the water in the pump. If it is started too early, the motor will be burnt due to excessive resistance and water hammer in the water pipe. In addition, if the pump is installed in the well, it should be noted that the flow of the pump should be consistent with the normal water output of the well, otherwise it will cause the empty machine to run and burn the motor.
In order to ensure the normal operation of the pump, it should be checked before use. 1. Check if the pump motor winding is open circuit with a universal meter. The insulation can be used for 500 volt megohmmeter measurements. When the insulation resistance is less than 0.5 megohm, the pump cannot be used. 2. Remove the filter and rotate the pump shaft for flexibility. If it is not flexible, it should be adjusted before use. 3. Whether the gate fuse capacity selection is appropriate, no other wires can be used instead of the fuse. 4. Turn on the power and check if the impeller is running normally (the power-on time must not exceed 3 to 5 seconds, otherwise the motor will burn out easily).
The Alternating Pressure Mattress System has 22 bladders for optimum pressure relief and a static function to allow treatment of the patient. Soft/ firm dial to obtain custom patient comfort levels. Ideal for those with history of breakdown or past skin issues. For the treatment or prevention of decubitis ulcers.
Alternating pressure devices typically utilize multiple bladders to facilitate routine patient turning. These devices may also assist the nursing staff to move the patient to change bedding and move the patient out of bed.
Low air loss devices are typically powered with blowers that run continuously. Air is allowed to escape through the device in specific areas designed to provide further comfort and treatment of the patient. The blower maintains constant air pressure and inflation of the device.
Static overlay mattresses are filled with a specific volume of air once prior to use. These devices are often used for the prevention and treatment of pressure ulcers (bed sores).
Product description
The device comes with all the necesary features for efficient decubitus prevention. It consists of
fewseparate elements. No tools are required for assembly. Devices are supplied in carton boxes,
detached in to few elements for easier transportation:
1 Pump
1 Mattress Pad
Anti-Decubitus Mattress Without Toilet
Anti-Decubitus Mattress Without Toilet,Durable Air Mattress,Alternating Pressure Mattress,Hospital Air Mattress
Shijiazhuang Laien Medical Devices Co., Ltd , http://www.laien-healthcare.com