1, can not start or start difficult: If the fuel tank is no oil, then you can add fuel; if the oil is not smooth, then clean the oil channel; if the fuel is dirty, there is water in the oil, you need to replace the fuel; if the cylinder into If there is too much oil, remove the spark plug for several revolutions and dry the spark plug; if the spark plug does not flash over, excessive coke or insulator is broken, remove the coke or renew the insulator; if the spark plug, platinum gap adjustment If it is improper, it should be readjusted; if the capacitor breaks down, the high-voltage wire is broken or detached, the high-voltage coil breaks down, etc., it must be repaired and renewed; if there is oil on the platinum or burned out, remove the oil or polish the burned part. 2, can start but the power is insufficient: If the supply of oil is insufficient, the main volume hole is blocked, the air filter is blocked, etc., it should be cleaned and dredged; if the platinum gap is too small or the ignition time is too early, it should be adjusted; if the combustion chamber carbon deposition If the temperature of the airframe is too high, the coke should be removed. If the cylinder liner, piston, and piston ring are seriously worn, replace the new one. If the mixing oil is too thin, increase the contrast. 3, the engine is not running smoothly: If the main components are seriously worn, there is a knocking phenomenon in the movement, and the parts should be replaced; if the ignition time is too early, there is a phenomenon of tempering, it must be checked and adjusted: if the platinum is worn or loose, it should be Renew or fasten; if there is water in the float chamber or oil is deposited, causing unstable operation, clean it. 4. Shut down suddenly during operation: If the fuel is burned, it should be refueled; if the high-voltage line falls off, the line can be connected; if the throttle control mechanism is disengaged, it should be repaired; if the spark plug is broken, it must be replaced. 5. Pesticide spraying is not atomized: if the rotation speed is low, it should be accelerated; if the nozzle axis in the ultra-low ejection nozzle is bent, there is debris or severe abrasion in the high pressure ejection nozzle, then corresponding measures shall be taken.
Cellulose Sponge
Cellulose Sponge, Cellulose Makeup Sponge, Cosmetic Cellulose Sponge
Qingdao Rongyan Cosmetic Appliance Co.,Ltd , http://www.cosmeticpuff.com
